| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Replacing the speaker in a Delta II/Argonaut II |
| From: | "Stuart Rohre" <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 6 Oct 2008 15:53:59 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
The hot audio output stage says to check for partially shorted coupling capacitor, or a by pass capacitor on the speaker output line. Sometimes there is a resistor in series with a cap, and if the cap shorts you will have hot audio stage. The leakage of DC thru a bad coupling cap could also cause the distortion. Stuart Rohre K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Delta 580 FS, PaulKB8N |
|---|---|
| Next by Date: | Re: [TenTec] Replacing the speaker in a Delta II/Argonaut II, Dr. Gerald N. Johnson |
| Previous by Thread: | Re: [TenTec] Replacing the speaker in a Delta II/Argonaut II, Bill Acito W1PA |
| Next by Thread: | Re: [TenTec] Replacing the speaker in a Delta II/Argonaut II, Dr. Gerald N. Johnson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |