Hello Bill:
Look at the remote speaker jack. It probably needs replacing. They get bent
w/ age and/or break inside. I've replaced several of them. The tongue in the
jack looses it's tension and arcs and/or doesn't make good contact when
closed.
Best regards,
Ralph Howes
W8BVH
----- Original Message -----
From: "Bill Acito W1PA" <w1pa@hotmail.com>
To: <tentec@contesting.com>
Sent: Friday, October 03, 2008 12:45 PM
Subject: [TenTec] Replacing the speaker in a Delta II/Argonaut II
>I have a Delta II that I am refurbing, and it appears that the internal
>speaker has
> some sort of issue or short. After a few minutes the audio gets very
> distorted, and
> the audio amp module gets very hot. An external speaker plugged into the
> external
> jack works fine, and the module stays cool.
>
> In looking at the how the rig's aluminum frame is put together, it looks
> like I have to
> completely disassemble the radio to get access to the screws that hold the
> internal
> speak in place.
>
> Has anyone ever done this replacement, and if so, is there an easier way?
>
> Bill
> W1PA
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|