I think I will dress up my Ten Tec gear with their offered
replacement rubber finger grip that surrounds some of the
large knobs with the Ten Tec grips IN COLORS.
Let see, I could have red for the remote encoder,
orange for left knob, etc., etc. Nice. 73
Charles Harpole
k4vud@hotmail.com
> From: ronc@sonic.net
> To: tentec@contesting.com
> Date: Tue, 17 Jun 2008 18:43:04 -0700
> Subject: Re: [TenTec] Tuner 238B
>
> I can't remember off the top of my head how the skirt is secured to the
> knob, but you can get the knob off by sliding the rubber finger-grip forward
> and off the front of the knob. That reveals the set screws. The
> finger-grip is on tight, so it takes a bit work to get it to move.
>
> Ron N6IE
> www.N6IE.com
>
>
> ----- Original Message -----
> From: "TMorton"
> To:
> Sent: Tuesday, June 17, 2008 5:38 PM
> Subject: [TenTec] Tuner 238B
>
>
>> My tuner has been in storage for about 3 years and finally made it to
>> the desk this week. I discovered the number skirt behind the Inductor
>> knob is not secure and slips as the knob is being turned. Any hints or
>> tips on how to secure this?
>> Tnx & 73
>> Tom
>> CX7TT
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|