Try pulling the rubber tire a bit to move it forward on the knob - it could
be that it has slid back and is rubbing against the skirt and forcing it to
move forward faster than the vernier is trying to move it.
73, Duane
Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of TMorton
Sent: Tuesday, June 17, 2008 7:39 PM
To: tentec@contesting.com
Subject: [TenTec] Tuner 238B
My tuner has been in storage for about 3 years and finally made it to
the desk this week. I discovered the number skirt behind the Inductor
knob is not secure and slips as the knob is being turned. Any hints or
tips on how to secure this?
Tnx & 73
Tom
CX7TT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|