I can't remember off the top of my head how the skirt is secured to the
knob, but you can get the knob off by sliding the rubber finger-grip forward
and off the front of the knob. That reveals the set screws. The
finger-grip is on tight, so it takes a bit work to get it to move.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "TMorton" <cx7tt@4email.net>
To: <tentec@contesting.com>
Sent: Tuesday, June 17, 2008 5:38 PM
Subject: [TenTec] Tuner 238B
> My tuner has been in storage for about 3 years and finally made it to
> the desk this week. I discovered the number skirt behind the Inductor
> knob is not secure and slips as the knob is being turned. Any hints or
> tips on how to secure this?
> Tnx & 73
> Tom
> CX7TT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|