Bob if you go to my website (link below) and open the Omni V.9 document
there's a blow by blow set of instructions to remove the keypad. It's in
the 2nd part of the document after the description of the Omni V.9 mod.
73,
Rick
VE7TK
Website: http://www3.telus.net/ve7tk
------------
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] frozen display
From: Bob Towers <mm0rkt@beeb.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 08 Aug 2007 16:06:59 +0100
List-post: <mailto:tentec@contesting.com>
Could anybody give me instructions on how to get the keypad panel off
the fascia plate of my Omni V? I need to replace the digital encoder. I
think the connector is 93.
I see there's a screw in each corner of the front panel. Undoing them
presumably releases the front panel. Does the key pad panel then come
loose at the same time?
73
Bob
MM0RKT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|