Richard Williams wrote:
> Allen,
>
> The way I read Bernie's question, he is asking about the thicker solid
> line that is directly above the spectrum display. There is a "break"
> (it becomes a thin line) in it just between the "0" and the next
> number (.6, 1.2, 2.5, 5, or 10 - depending on the sweep range) to the
> left.
>
> I read it this way because Bernie says: "Immediately above the
> spectrum sweep scope is a horizontal line on which the rectangles
> representing the bandpasses for the main (left) and sub (right)
> receivers rest". The rectangles don't "rest" on the the horizontal
> line(s) above the filter bandwidth graphic; which you correctly
> defined in your response.
>
> Personally, I don't know what the break in the bar represents;
> interesting question, do you happen to know the answer?
>
> Dick K8ZTT
>
>
>>
>> ----- Original Message ----- From: <K5XS@aol.com>
>> To: <tentec@contesting.com>
>> Sent: Saturday, January 20, 2007 8:14 AM
>> Subject: [TenTec] O-2 Screen Lines
>>
>>
>>
>>>
>>> > Immediately above the spectrum sweep scope is a horizontal line on
>>> > which
>>> > the
>>> > rectangles representing the bandpasses for the main (left) and sub
>>> > (right)
>>> > receivers rest. The line has a break in it, and it is decidedly off
>>> > center
>>> > (to the lest a bit).
>>> >
>>> > Does that line represent something? Does the break represent >
>>> something?
>>> >
>>> > Thanks
>>> >
>>> > Bernie K5XS
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> Richard, Thanks. Now I realize that I mis-read Bernie's message.
> Off hand, I do not know about the line he mentions, but I shall look
> into it. 73, Allan, W1AEL
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|