TenTec
[Top] [All Lists]

Re: [TenTec] ORION Display (horizontal line??)

To: <w1ael@arrl.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] ORION Display (horizontal line??)
From: "Richard Williams" <richardw@mho.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 22 Jan 2007 18:47:36 -0700
List-post: <mailto:tentec@contesting.com>
Allen,

The way I read Bernie's question, he is asking about the thicker solid line 
that is directly above the spectrum display.   There is a "break" (it 
becomes a thin line) in it just between the "0" and the next number (.6, 
1.2, 2.5, 5, or 10 - depending on the sweep range) to the left.

I read it this way because Bernie says:  "Immediately above the spectrum 
sweep scope is a horizontal line on which the rectangles representing the 
bandpasses for the main (left) and sub (right)  receivers rest".   The 
rectangles don't "rest" on the the horizontal line(s) above the filter 
bandwidth graphic; which you  correctly defined in your response.

Personally, I don't know what the break in the bar represents;  interesting 
question,  do you happen to know the answer?

Dick K8ZTT


----- Original Message ----- 
From: "Allan H. Kaplan" <w1ael@arrl.net>
To: <tentec@contesting.com>
Sent: Monday, January 22, 2007 6:14 PM
Subject: Re: [TenTec] ORION Display


> The horizontal line above the filter bandwidth graphic represents the
> bandwidth of the roofing filter in use at 9 MHz.  The filter bandwidth
> graphically represents the ultimate selectivity implemented by the
> BANDWIDTH control in the DSP IF and the (wider) roofing filter gets
> selected automatically based on the BW control.  Hope this helps. 73,
> Allan, W1AEL in Sevierville, TN.
>
> ----- Original Message ----- 
> From: <K5XS@aol.com>
> To: <tentec@contesting.com>
> Sent: Saturday, January 20, 2007 8:14 AM
> Subject: [TenTec] O-2 Screen Lines
>
>
>
>> > This is truly fun.  I am figuring out the radio and trying to discover
>> > every
>> > little nook and cranny on it.
>> >
>> > One thing has me puzzled, and I can't find it in the manual.
>> >
>> > Immediately above the spectrum sweep scope is a horizontal line on 
>> > which
>> > the
>> > rectangles representing the bandpasses for the main (left) and sub 
>> > (right)
>> > receivers rest.  The line has a break in it, and it is decidedly off
>> > center
>> > (to the lest a bit).
>> >
>> > Does that line represent something?  Does the break represent 
>> > something?
>> >
>> > Thanks
>> >
>> > Bernie K5XS
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>