Speaking of my little Argosy -- it's time to rebuild the PTO. It's not
all that flaky, but could use the attention anyway. Besides, i have a
ten Tec PTO rebuild kit on hand, so why not do it?
>
> The first step. of course, is to remove the PTO. How does one do
> this? I'd rather learn the procedure from someone who's "been there"
> than to tear down the rig more than necessary. I'm guessing the PTO
> is held in place by screws behind the front panel since I see no other
> obvious anchor points. It also looks as if wires need to be unsoldered
> from feed-through terminals and a ground lug on one side of the unit
> -- but that's it. Am I correct?
>
> Many thanks and 73,
>
> Craig
> W3CRR
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|