Speaking of my little Argosy -- it's time to rebuild the PTO. It's not
all that flaky, but could use the attention anyway. Besides, i have a
ten Tec PTO rebuild kit on hand, so why not do it?
The first step. of course, is to remove the PTO. How does one do this?
I'd rather learn the procedure from someone who's "been there" than to
tear down the rig more than necessary. I'm guessing the PTO is held in
place by screws behind the front panel since I see no other obvious
anchor points. It also looks as if wires need to be unsoldered from
feed-through terminals and a ground lug on one side of the unit -- but
that's it. Am I correct?
Many thanks and 73,
Craig
W3CRR
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|