On Thu, 2007-01-11 at 12:11 -0400, VE1BN wrote:
> Hi John -
>
> Have not located the pot value on my OMNI 6+ schematic either.
> Now I'm as curious as you are. My pot covers over full two dial marks
> (55 degrees) between 15 and 30 wpm.
>
> Not much room for a 10-T pot though behind the panel.
>
> Think the best approach is to contact Don Prouty at T-T. Just the
> cost of a phone call to find out without having to lay the front
> panel down and measure it yourself.
>
> I don't use the built-in keyer, just a CMOS Superkeyer 3 instead.
>
> 73 - Don
Once you've measured the values that set the limits of the speed range
you wish, you should be able to use a fixed (or adjustable) series
resistor to set the high and a resistor shunting the panel variable to
set the width of the range. I have no idea what the original values are
though.
--
73, Jerry, K0CQ,
All content copyright Dr. Gerald N. Johnson, electrical engineer
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|