On Wed, 10 Jan 2007 11:47:54 -0700 "Harry G. McGavran Jr. " wrote:
>
> I have a brand new Orion II I am trying to
> hook up for QSK CW using my Ameritron 811H
> and Ameritron QSK-5.
>
> On the Ten-Tec web site is the following
> description of how to hook up a QSK-5:
>
> ===============================================
>
> Ameritron with the QSK 5:
>
> Refer to Figure 2A in the QSK-5 manual. Key 2 goes to
> TX OUT on the Ten-Tec Transceiver. Key 1 and AUX jacks
> are connected together with a Y cable and the third
> leg of the Y goes to TX EN on the Ten-Tec Transceiver.
>
> ===============================================
>
.
.
.
This was finally resolved by placing a 1N4001 diode in series
in the line from the QSK-5 AUX/KEY-1 to the Orion TX EN. The
cathode of the diode is on the QSK-5 AUX/KEY-1 side and
the anode is on the Orion TX EN side. Now it works as
it should...
73 --
Harry, W5PNY
--
Harry G. McGavran, Jr.
E-mail: w5pny@arrl.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|