bsd crystal? All other bands ok/
----- Original Message -----
From: "Patti" <pthielking@earthlink.net>
To: <tentec@contesting.com>
Sent: Saturday, December 24, 2005 14:23
Subject: [TenTec] HInts for troubleshooting an OMNI D
> Intermittantly, while operating on 80m (sending or just receiving) my
OMNI D will fade out, with
> the display simply reading 1.000. Once this occurs, you can no longer
send and receive.
>
> Turning the power off momentarily, or changing bands seems to help, for a
short duration.
> This behaviour only occurs on 80.
>
>
> Any ideas on where to start looking? From reading the manual, I
considered the VFO AMP board, although this is not band dependant.
>
> Any ideas would be appreciated. I can be contacted off list as well.
>
> Thanks
> Eric Thielking
> NC2W
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|