On Sat, Dec 24, 2005 at 09:23:15AM -0500, Patti wrote:
> Intermittantly, while operating on 80m (sending or just receiving) my OMNI D
> will fade out, with
> the display simply reading 1.000. Once this occurs, you can no longer send
> and receive.
>
> Turning the power off momentarily, or changing bands seems to help, for a
> short duration.
> This behaviour only occurs on 80.
>
>
> Any ideas on where to start looking? From reading the manual, I considered
> the VFO AMP board, although this is not band dependant.
>
> Any ideas would be appreciated. I can be contacted off list as well.
>
> Thanks
> Eric Thielking
> NC2W
Eric, try reseating the jumper for txin-txout. Check connections inside the
rig, a gentle push or a reseat should work. It may also be in the bandswitch or
possibly the crystal may need to be reseated. HTH
Ed W3NR
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|