Here's where to look for Sony parts.
Sony National Parts Center
Attn: Customer Service
8281 NW 107 Terrace
Kansas City, MO 64153
PH 816-891-7550
73
Bob, K4TAX
----- Original Message -----
From: "A Sewell" <alan.n5na@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, December 17, 2005 8:17 AM
Subject: Re: [TenTec] Orion....Best Headphones?
> I'm using some Sony MDR-V600 headphones with my Orion and really like
> them. The only problem I have had is the covering on the headband has
> come apart. It is a very thin plastic material. So far I haven't been
> able to find a replacement covering. I have had them a couple of years.
>
> If I were buying headphones now I would consider the Sennheiser HD 580.
> Great reviews on eHam. They are about $150 on the internet.
>
> 73,
>
> Alan N5NA
>
> Reed O. Krenn wrote:
>> On Fri December 16 2005 17:29, John wrote:
>>
>>> Hi folks.......anyone gone through headsets and found a set that works
>>> well
>>> with the Orion? I've got 4 pair of pretty good phones, but none seem to
>>> do
>>> real well with the Orion, even when the impedance is a good match?
>>>
>>> John K4NP ......no, I don't need a mic attached : )
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>> Hi John -
>>
>> FWIW, Santa is allegedly bringing me a pair of Sony MDR-V600 headphones.
>> He
>> was looking for MDR-V7506 (Highly recommended by some friends and getting
>> rave reviews on eham), but they seem to be out of print. The MDR-V600
>> seems
>> like it may be the successor. Impedance is 45 ohms.
>>
>> I'll report back sometime after I wash the reindeer effluvia off my roof!
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|