Steve N4LQ wrote:
>Ron
>Tx Loop button? What's that? In the "Transmitter" menu, I have a "Enable
>keying loop" button. Is that what you meant? I have mine disabled since I
>don't use a TT amp with the Peg. On your N4PY front panel, do you have the
>"Xmit Disable" activated? If so, disable it. Also check the "ACCInp" button.
>For microphone input it should be disabled.
>If all this doesnt work, try the basic TenTec software and start all over.
>Out of ideas. 73
>Steve Ellington
>N4LQ@iglou.com
>----- Original Message -----
>From: "Ron" <k8fg@sbcglobal.net>
>To: <tentec@contesting.com>
>Sent: Saturday, March 19, 2005 2:16 PM
>Subject: [TenTec] NO XMIT WITH PTT
>
>
>
>
>>Hello to the Group,
>>I have a couple of questions .
>>I have a Pegasus that will not Xmit via the Mic or Acc jacks
>>but will key via the N4PY software with a mouse click on the
>>TX Loop button.. Any ideas ?
>>
>>Also is there ant service info available ?
>>Thanks, Ron/K8FG...
>>_______________________________________________
>>TenTec mailing list
>>TenTec@contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
Hi Steve and Carl,
I have the latest ver of software and in the top row of buttons there is
a Tx Loop button after the Calibrate.
When I left click on this button it will go into xmit. If I go into the
settings/transmitter menu and
uncheck Keying Loop the rig goes into xmit. ACCInp is disabled.
I am starting to believe I have a rig problem, if I short the Ptt pin in
the mic connector to ground
there is no xmit also did the same test with the Acc connector with the
same results.
Ron/K8FG...
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|