Re: [TenTec] Jupe+n4py+mixw2

[Charles Greene <W1CG@QSL.NET>]

Jerome,

With MixW and the N4PY program,  in MixW go Configure-TRCVR CAT/PTT-TEN 
TEC-Pegasus \ Jupiter (emulation mode) and fill in the software path.   Now 
the MixW will import the frequency/andd/mode from MixW and control 
frequency/band/mode.  I use a hardware interface from MixW to the serial 
port DRT or RTS line to the PTT line in the Jupiter in the Accessory 
plug.  This line is the same as the CW key line. The N4PY has a CW 
keyboard, but I didn't try that while using MixW.

73,

W1CG

At 01:21 AM 10/14/2004, jerome schatten wrote:
> I googled on this and I think there may have been some discussion on it in
> 2003, however I found nothing really relevant.  I'm running a Jupiter and
> most of my time is spent on cw. Occasionally, when I can't make my bug go
> fast enough, long enough, I wish to use a keyboard to send. Using  MixW2
> meets my needs for a simple vox driven cw keyboard. N4py meets my needs for
> rig control.  I'm using a rather lame p100 with 32 megs of  which ram works
> ok using either programme, but as you might guess, not both at the same
> time.
>
> I'm going to be pushing my pIII 450 with 256 megs of ram down to the shack
> and getting rid of the p100 very shortly. My question is: Will I then be
> able to use the N4PY software set for ssb to control the rig and MixW2 to
> send keyboard CW (MCW actually using the sound card and ssb.) and have them
> both up on the screen at the same time? I've listened to the note generated
> on my ft920, checked for crud on the sides and it seems ok as long as
> everything is set up properly.  Or... is there a better way?
>
> So... was I compute bound with the lame machine or is there something else
> at work here?  Appologies if this has been asked before.
>
> Jerome - VA7VV


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec