Yes Mark, I had the headphones on so I could switch the audio to Main and
Sub later, to check the levels that way also. Also during normal operating,
I wear headphones. If I can get my keying issue cleared up tonight, I'll
load v1.371 and see if I can confirm that problem and if so, will report it
to the programmer. Will also let you know what I find, IF I can get to it
tonight.
Tom - W4BQF
----- Original Message -----
From: "Mark Erbaugh" <mark@microenh.com>
To: <tentec@contesting.com>
Sent: Friday, July 23, 2004 4:20 PM
Subject: Re: [TenTec] Orion Aux I/O Audio Problem
> Tommy,
>
> Thanks for checking. Did you try your test with headphones plugged in?
If
> headphones aren't plugged in, I can mute the audio and the audio stays on
> the Aux I/O connector.
>
> It would be interesting to know if the problem is related to v 1.371 or
just
> to my Orion.
>
> Mark
>
> ----- Original Message -----
> From: "Tommy" <aldermant@alltel.net>
> To: <tentec@contesting.com>
> Sent: Friday, July 23, 2004 3:06 PM
> Subject: Re: [TenTec] Orion Aux I/O Audio Problem
>
>
> > Hi Mark,
> >
> > I have two Orions and they do not exhibit what you are seeing. I
primarily
> > operate CW and use TuneWin to zero beat others, I also use Pin 4 for the
> > audio to my PC and would readily notice if audio went away. I just
checked
> > and the only time I lose audio is if I change the Audio Menu Left
channel
> to
> > SUB. Audio is present, at it's constant level if I drop the main audio
> > level to zero and if I mute it by pressing the Main AF control.
> >
> > I'm switching back and forth between v1.369 and v1.372, but have not
used
> > v1.371 recently.
> >
> > Tom - W4BQF
> >
> > ----- Original Message -----
> > From: "Mark Erbaugh" <mark@microenh.com>
> > To: <tentec@contesting.com>
> > Sent: Friday, July 23, 2004 11:49 AM
> > Subject: [TenTec] Orion Aux I/O Audio Problem
> >
> >
> > > I wonder if other Orion owners have encountered this problem?
> > >
> > > I have my computer soundcard input connected to Pin 4 of the Aux I/O
> jack
> > on
> > > the back of the Orion. According to the documentation, this pin is
Left
> > Side
> > > Audio Output. I have Left, Right and Speaker configured to the main
> > > receiver. With stereo headphones plugged in to the front panel
> headphone
> > > jack, I hear the audio in both ears as expected and the computer
appears
> > to
> > > be receiving fixed level audio. The audio level does not change as the
> > main
> > > AF gain control is adjusts.
> > >
> > > Except - if I turn the main AF gain all the way down or mute the audio
> by
> > > pushing the AF gain encoder, the audio going to the computer goes
away.
> > If
> > > I unplug the headphones and mute the audio to the speaker, the
computer
> > > still gets audio.
> > >
> > > This is with firmware 1.371.
> > >
> > > 73,
> > > Mark
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|