I use calipers and a converion chart.
You could always buy a drill guage though.
Bill Fulling wrote:
Hi folks,
Many years ago when I was in the Navy we were issued in our ET toolboxes a wire
guage-it was about 2 1/2' in diameter and was used sort of like a spark plug
gapper-was used to ID the AWG diameter of unknown wires(go-no go).Does anyone
know if these are still available;I'd like to buy one.
73 de Bill W4NJF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|