I have used a 259 thru two (my switching arrangement) Alpha Delta switches
for years to tune the antenna and never had a problem. They seem to isolate
well and short unused inputs/outputs.
Also...the question was how or can it (changing tune to 15W) be
accomplished. It's comical to read the posts that demand that the questioner
change his procedure instead of giving him an answer to his question.
Chuck, KE9UW
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Eric Scace K3NA
> Sent: Wednesday, February 04, 2004 21:43 PM
> To: Rick@dj0ip.de; tentec@contesting.com
> Subject: RE: [TenTec] Orion Question
>
>
> Hi Rick --
>
> I wasn't suggesting using an antenna switch to connect the
> antenna analyzer or the radio to the tuner. As you pointed out, many
> switches have inadequate isolation. What I had done in the past
> was disconnect the coax from the back of the transceiver and
> connect that coax to the antenna analyzer.
>
> -- Eric
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Rick Westerman
> Sent: 2004 February 4 10:07
> To: eric@k3na.org; tentec@contesting.com
> Subject: RE: [TenTec] Orion Question
>
>
> Sorry Eric, NOT a good reply.
>
> In fact that's a good way to blow out MFJ 259's.
> (been there, done that)
>
> I also tune the linear with low power (here 15 or 20w wouldn't
> matter).
> I can't tune the linear, driving it from the MFJ.
>
> Years ago I connected my MFJ 259 via an SPDT coax switch and did
> just what you suggest.
> The result was in a very short time the MFJ was dead.
> Apparently there wasn't enough isolation in the switch.
> Since then I always remove it completely from the feedline before
> applying power.
>
> What I do though, is periodically tune the matchbox on all bands
> using the MFJ-259B and create a table of pre-sets.
> Then I remove the MFJ and after each band change, set to the
> matchbox to the table's pre-set values and then apply low power
> to fine tune. My wish is for 15w out when I press the "TUNE"
> button.
>
> Thanks anyway.
>
> 73
> Rick
>
>
>
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Eric Scace
> K3NA
> Sent: Wednesday, February 04, 2004 4:52 PM
> To: Rick@dj0ip.de; tentec@contesting.com
> Subject: RE: [TenTec] Orion Question
>
>
> If you have an antenna analyzer like the AEA or MFJ units, the
> best way to tune your matchbox is to connect the antenna
> analyzer.
> These analyzers put out about 1 mW and you can see exactly the
> impedance. Note the settings for each band (or frequency within
> a
> band). Then hook up your radio and go -- no need for further
> tweaking.
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Rick Westerman
> Sent: 2004 February 4 09:36
> To: tentec@contesting.com
> Subject: [TenTec] Orion Question
>
>
> Is it possible to change the output power of the "TUNE" button
> from 20w to 15w?
>
> My watt meter peaks at 15w or 150w.
> It would be nice to have just 15w for matchbox tuning purposes.
>
> Tnx.
>
> 73
> Rick
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> ---
> Incoming mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.574 / Virus Database: 364 - Release Date: 1/29/2004
>
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.574 / Virus Database: 364 - Release Date: 1/29/2004
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|