I haven't measured it with a QRP wattmeter, Bob...mainly because I
haven't assembled the kit yet! But T-T rates the output at 0-100 watts
and you have measured it at one watt, so I'm pretty sure that it will
go down to five watts reliably.
I'm tempted by the 756 Pro, as well as by the FT-1000D or MP...a lot of
both get taken on DXpeditions, so they must have something going.
This discussion goes around from time to time, and I'm glad to hear
some comparisons with the Japanese top-of-the-line radios and the Omni
6+ in terms of CW operation, which is the reason that a lot of us who
bought the 6+ did so.
73 de Jim - AD6CW
BobEZWRITER@aol.com wrote:
>
> Well, been listening to the debate about the Pro vs. the 6+. i was going to
> buy the Pro, but got a used 6+ instead. not as fancy, but does everything i
> want on CW. no real bells and whistles, but with my 250 hz cw filter, i can
> work everything. with a dipole at 25' worked all over the world.
>
> a question for u Omni 6+ owners. Ten Tec i think says the 6+ won't go below
> 8 watts. yet on my external watt meter, i can tune it down to nearly 0
> watts. on 1 watt on my ext. watt meter being shown, i've worked Japan on my
> dipole.
>
> Have any of u folks found u can QRP with the 6+ below 8 watts?
>
> 73, Bob, KZ2G
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|