I hope someone has a good answer for this because
a similiar, maybe the the same, thing happened to me last week
except receiving only in USB. Could bearly hear in CW or LSB but s meter
was working on signals there.
Did partial and full resets--nothing.
Decided to call Ten Tec but their line was busy for about 2 hours.
When I did get through, It was working FINE!!
Paul had no suggestions except send it in.
Any one out there have any?
Bill W5EC
----Original Message-----
From: Clark Savage Turner <csturner@falcon.csc.calpoly.edu>
To: tentec@contesting.com <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Saturday, March 03, 2001 17:38 PM
Subject: [TenTec] OMNI VI t/r problem, clues?
>
>Well, the receiver is fine but after a long time I decided to transmit.
>Nothing! No T/R action. The receiver barely mutes. The ALC light does
>not come on (like the time static discharges took out the diodes on the
>SWR board...) when I hit the PTT in SSB. Of course, since the receiver
>does not mute, no output on transmit. In fact, the S meter still reads
>received signal strength even when I hit the "tune" button. Sounds like
>it must be simple (or even pilot error!!!) Any clues for me?
>
>Clark
>WA3JPG
>
>
>--
>FAQ on WWW: http://www.contesting.com/FAQ/tentec
>Submissions: tentec@contesting.com
>Administrative requests: tentec-REQUEST@contesting.com
>Problems: owner-tentec@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|