I checked my Omni VI+ last night for Vince thinking the same thing - that the
metering was inaccurate, but found that full output measured 100w on both the
VI+ and the Model 238 (compared to my Autec WM-1). When the drive was dropped
to indicate 20W on the Omni, it was 22W on the Autek and 24W on the Model 238
tuner. This held true on both 40m and 10m into a dummy load. FWIW...
73, Duane
------Original Message------
From: "dbudd" <w5ben@arrl.net>
To: vsantis@javanet.com, "Tentec (E-mail)" <tentec@contesting.com>
Sent: December 20, 2000 12:11:22 PM GMT
Subject: RE: [TenTec] Herc II drive power
I did not check the output of the Omni VI with the Bird, but
my omni shows about 20 watts for full output on 80M. On
10M, it takes a little less than 25 watts.
73,
Duane Budd
w5ben@arrl.net
-----Original Message-----
From: owner-tentec@contesting.com
[mailto:owner-tentec@contesting.com]On
Behalf Of Vincent A. Santis
Sent: Tuesday, December 19, 2000 17:27 PM
To: Tentec (E-mail)
Subject: [TenTec] Herc II drive power
HI,
I have an anomile witth my Hercules II, I get full output
(500watts) with
only about 20 watts of drive showint on my Omni VI+ meter.
Meter readings
on the Herc look OK. Any ideas?
Vince Santis, N1VS
Winsted, CT
--
FAQ on WWW:
http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|