Are you sure the Omni's meter is on fwd power and not collector current (in
amps)? Mathematically this won't work. Either you have a bad meter on one of
the rigs you are reading one of them wrong. I would suggest you put a dummy
load on each and find out where your going wrong.
Steve Ellington
N4LQ
-----Original Message-----
From: Vincent A. Santis <vsantis@javanet.com>
To: Tentec (E-mail) <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Tuesday, December 19, 2000 7:04 PM
Subject: [TenTec] Herc II drive power
>
>HI,
>
>I have an anomile witth my Hercules II, I get full output (500watts) with
>only about 20 watts of drive showint on my Omni VI+ meter. Meter readings
>on the Herc look OK. Any ideas?
>
>Vince Santis, N1VS
>Winsted, CT
>
>
>--
>FAQ on WWW: http://www.contesting.com/FAQ/tentec
>Submissions: tentec@contesting.com
>Administrative requests: tentec-REQUEST@contesting.com
>Problems: owner-tentec@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|