John,
It has to be a custom cable with the two wires reversed as in the diagram
from Ten Tec. A standard serial will not work.
Rich
> -----Original Message-----
> From: owner-tentec@contesting.com [mailto:owner-tentec@contesting.com]On
> Behalf Of John & Annette Nicholson
> Sent: Sunday, December 27, 1998 12:00 PM
> To: tentec@contesting.com
> Subject: [TenTec] Omni VI: DB9 vs DB25
>
>
>
> Hello,
>
> I am in the process of connecting my Omni VI to a 9 pin serial connector
> on the back of my pc (the only available I/O port). I see the wiring
> diagram in the TT Manual...is this a standard wiring configuration to
> go from the 25 pin on the back of the Omni to the 9 pin on my pc? Or
> do I need to specially wire my own cable? My old pc had a 25 pin
> serial port so was no problem. Today I tried a 25 pin to 25 pin cable with
> a 9 pin adapter...but it didn't work. Any ideas?
>
> Thanks...and Happiest of New Year's to all...
>
> 73 K7FD John
> http://www.netbridge.net/dx
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|