I have my Omni 6+ hooked up direct to my pc using a standard serial cable
and an adapter from 25 to 9 (9 going into the pc) with no problem. One of
the best selling points of the Omni 6 was the fact that you didn't need a
special cable, a standard serial cable should work. Does with both of my
Omnis.
73, Chris KB3A
At 12:08 PM 12/27/98 -0600, you wrote:
>
>John,
>
>It has to be a custom cable with the two wires reversed as in the diagram
>from Ten Tec. A standard serial will not work.
>
>Rich
>>
>>
>>
>> Hello,
>>
>> I am in the process of connecting my Omni VI to a 9 pin serial connector
>> on the back of my pc (the only available I/O port). I see the wiring
>> diagram in the TT Manual...is this a standard wiring configuration to
>> go from the 25 pin on the back of the Omni to the 9 pin on my pc? Or
>> do I need to specially wire my own cable? My old pc had a 25 pin
>> serial port so was no problem. Today I tried a 25 pin to 25 pin cable with
>> a 9 pin adapter...but it didn't work. Any ideas?
>>
>> Thanks...and Happiest of New Year's to all...
>>
>> 73 K7FD John
>> http://www.netbridge.net/dx
>>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|