Kevin,
TNX but does not work here. Works with my home built keyers but not with
Winkey 3.1 - it is initialized to its default state which has sidetone =
on. CW TONE = 0 does not override it ... this is THE PROBLEM...
73,
Martin, OK1RR
Dne 31. 05. 22 v 1:24 w9cf@arrl.net napsal(a):
CW TONE = 0
in LOGCFG.DAT (or equivalent) should turn off the sidetone.
73 Kevin w9cf
On Tue, May 31, 2022 at 01:09:44AM +0200, Martin Kratoska wrote:
Among others I own also the Microham DXP which has a Winkeyer v.3 chip
inside. The bad thing is that at every start the Winkeyer is initialized to
the default Host Mode state which means that the sidetone is on.
The sidetone is actually needed only in Command Mode, otherwise the keyer
should be silent. Now I must switch off the sidetone with A command after
every program start which is annoying. What I missed? Is there a hidden
switch allowing to start the keyer into silent state?
73,
Martin, OK1RR
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|