Folks,
You might increase the POLL RATE command so the PC asks the rig's frequency
more often. I haven't tried this because of the junk PCs used here: the
extra overhead might cause grief if the poll time is set too short, but this
probably won't be a problem for you...
73 de Bob, K6XX
k6xx@arrl.net
www.k6xx.com
-----Original Message-----
From: owner-trlog@contesting.com [mailto:owner-trlog@contesting.com]On
Behalf Of VR2BrettGraham
Sent: Sunday, December 02, 2001 10:16 PM
To: trlog@contesting.com
Subject: Re: [TRLog] Bandmap Inconsistencies
DL2ZAV has noted his bandmap slowly fills with CQ-####s whilst SO2R
CQing on an uninterfaced rig & S&Ping on one which is.
Having just finished two single band CQ WW efforts where much time was
spent S&Ping on the sub-RX of the CQing rig, I figured I'd add an
observation:
Because of the time between polls of the radio, after finishing working the
new mult, I found I jumped back to CQing after swapping VFOs on the rig
faster than TRlog could follow. In other words, it still was using the
frequency
from the mult & since I sent out a CQ before it polled the rig, it knew no
better than to replace the mult in my bandmap with an indication of my CQ.
Workaround: wait just a little longer after swapping VFOs before CQing
again. Admittedly hard to do when one steps out of a good run, bags the
mult
& want to get back to the run like you've never left it...
73, VR2BrettGraham
--
FAQ on WWW: http://www.contesting.com/FAQ/trlog
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
--
FAQ on WWW: http://www.contesting.com/FAQ/trlog
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|