Jimmy Weierich wrote:
>
> I've not had the problem of a call not clearing out. At least not if I
> stop tuning long enough for the frequency shown under the Band/Mode to
> update to the current rig frequency.
>
> I have occasionally had the problem of the call in the bandmap not
> popping into the call window for as long as I can remember.
>
> I just loaded about thirty calls into the bandmap and tuned up and down
> the map for about 20 minutes and managed to make this happen three
> times. There seemed to be no relation between the age of the spot, or
> anything else I could see, and the occurrences. In each case the entry
> in the bandmap was blinking, the frequency in the band map was the same
> as that under the Band/Mode, and the call window was empty. Once this
> happened with a call that call would not appear even if I tuned away and
> back again, regardless of for how long or how many other calls were
> posted to the call window. The only way I could make the call in
> question again appear in the call window was to go to CQ mode and then
> back to S&P.
>
> On the second occasion when this happened I got a message under the
> exchange window that said "Enter frequency for W1AR in kHz:". On the
> other two occasions no message appeared.
>
This is precisely the kind of behavior I've seen. All running DOS without
Windows.
73,
Scott K9MA
--
Scott Ellington
Madison, Wisconsin USA
sdelling@facstaff.wisc.edu
--
FAQ on WWW: http://www.contesting.com/FAQ/trlog
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|