DL2ZAV has noted his bandmap slowly fills with CQ-####s whilst SO2R
CQing on an uninterfaced rig & S&Ping on one which is.
Having just finished two single band CQ WW efforts where much time was
spent S&Ping on the sub-RX of the CQing rig, I figured I'd add an observation:
Because of the time between polls of the radio, after finishing working the
new mult, I found I jumped back to CQing after swapping VFOs on the rig
faster than TRlog could follow. In other words, it still was using the
frequency
from the mult & since I sent out a CQ before it polled the rig, it knew no
better than to replace the mult in my bandmap with an indication of my CQ.
Workaround: wait just a little longer after swapping VFOs before CQing
again. Admittedly hard to do when one steps out of a good run, bags the mult
& want to get back to the run like you've never left it...
73, VR2BrettGraham
--
FAQ on WWW: http://www.contesting.com/FAQ/trlog
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|