N1MM+ does not use the digital configuration box if using MMTTY. The FSK
and PTT com ports are setup in the MMTTY configuration. You probably
have to use EXTFSK in MMTTY also. I have the Rigblaster Advantage so
there may be differences, but not in the N1MM+ and MMTTY setup.
I am not familiar with the Icom commands or setup. But I think PTT and
FSK should be on the same com port.
Feel free to contact me directly if you think I can help.
73, Tom W1TO
On 6/6/2016 8:35 AM, Joe Subich, W4TV wrote:
It is likely that you have not configured N1MM+ for PTT by software
command - try checking the appropriate "PTT Control via Software
Command" boxes in the CAT set-up (Config -> Configure Ports ... then
"Set" for the Radio port). WriteLog's "Comm PTT" defaults to ON for
Icom rigs which does PTT by software command.
73,
... Joe, W4TV
On 6/6/2016 1:08 AM, Phil wrote:
Joe and Rich,
Thanks for your comments.
I use a WMR cable form the RB to the ACC-1 connector on the Icom.
This is
the same cable I used with the old PC and true serial cables for years.
I never used the Mic connector.
My gut tells me that the RB should activate PTT thru ACC-1, but RB
Technical
Support says it's only used for received audio. They say I must use
Mic or
CI-V. I'm using the RB in the same way as before: Rig Control on
connector
B and FSK on connector A. Therefore I have not changed any internal RB
jumpers. I'm really confused.
Phil
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|