> RB is connected to IC-7700 Aux port and CI-V.
What signals are connected from the RigBlaster Pro to the IC-7700 ACC
jack? Do you have *both* FSK (pin 1) and PTT (pin 3) connected to the
ACC jack (ground/common pin pin 2)?
> Does anyone know the path of the PTT signal from the RB to the 7700?
Unless you connect PTT output from your interface to the HSEND line
on ACC[1] or the PTT line on the mic jack, your interface can not
assert PTT on the IC-7700 (an Icom transceiver).
73,
... Joe, W4TV
On 6/5/2016 1:01 PM, Phil wrote:
I am using N1MM to connect to a Rigblaster Pro via two WMR USB/serial
cables,
When trying to send an FSK RTTY message the following occurs:
Hear a relay "click" from the RB.
RB Green CS LED comes on.
RB Red PTT comes on.
RB Red FSK comes on and blinks to follow RTTY data.
RIG IS NOT PUT IN TRANSMIT MODE.
If I manually activate rig, RTTY signal is transmitted.
RB is connected to IC-7700 Aux port and CI-V.
No Mic connection.
Does anyone know the path of the PTT signal from the RB to the 7700?
As info, Rig Control works fine on RB connector B and all worked fine before
change from true serial cables to USB/serial cables. Also changed PC and
software from Writelog to N1MM.
Thanks.
Phil
WA2LXE
wa2lxe@optonline.net <mailto:wa2lxe@optonline.net>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|