What logger?
I've never seen the audio level change when additional receive-only windows
are added to either N1MM Logger or WriteLog.
By "fixed audio output jack on the rear of the K3", do you mean LINE OUT?
LINE OUT is not fixed but settable in the CONFIG menu. I recommend keeping
it below 10 and setting the Windows Sound Card Line In level such that you
can dynamically adjust the no-signal level to near the bottom of the audio
spectrum display with K3 LINE OUT values of 1-10.
73,
Ed - W0YK
-------------------------
Ed Muns
www.w0yk.com
> -----Original Message-----
> From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of
> RLVZ@aol.com
> Sent: Friday, June 07, 2013 8:22 PM
> To: rtty@contesting.com
> Subject: [RTTY] 2Tone problems
>
> Hi Guys,
>
> I'm finally setup with 2 RTTY Windows: MMTTY & 2Tone. And
> I've got a couple of problems:
>
> 1) As soon as I added the 2Tone as my 2nd window, I noticed
> the audio level on the MMTTY window dropped about two-thirds
> and MMTTY doesn't decode very well anymore.
>
> 2) 2Tone decodes the received signals fine but only decodes
> my transmit message about one-third of the time. Any ideas
> how I can get it to decode my transmit message all the time?
>
> Rig: K3 feeding a Windows 7 computer motherboard soundcard
> from the fixed audio output jack on the rear of the K3.
>
> Thanks!
>
> Dick- K9OM
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|