On 02/08/2013 03:24 PM, ham@n0sq.us wrote:
I want to try fldigi but it doesn't seem to have support for the TS2000.
The TS2000 is fully supported by the application flrig, which functions
for fldigi much in the same way that HRD provides the xcvr interface for
DM780 (which by the way is old fldigi code).
see on line help http://www.w1hkj.com/flrig-help/index.html
see supported transceivers http://www.w1hkj.com/flrig-help/flrig_rigs.html
BTW, you did not tell us what the KAM is printing while all of this is going
on...
is it printing nothing, is it printing complete gibberish, or is it printing a
bunch of weird but repeating characters during diddles, or is it printing
correct
characters now and then? Telling us that can help zeroing in on the problem.
It's printing gibberish due to noise and nothing when receiving a signal. I can
hear the diddles in the TS450 speaker so I'm receiving at least that much.
Make sure that the mark / space sense is the same for both transmit and
receive paths. Mark should always be higher in frequency than space.
Also make sure you are not overdriving the TS450 with your local signal.
73, Dave, W1HKJ
http://www.w1hkj.com
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|