RTTY
[Top] [All Lists]

Re: [RTTY] USB-Serial

To: <rtty@contesting.com>
Subject: Re: [RTTY] USB-Serial
From: "Jim McDonald" <jim@n7us.net>
Date: Mon, 13 Jun 2011 13:25:08 -0500
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
I bought a used Edgeport/4 for $30 last August on eBay.  I later learned
that they were selling 8-port ones for $35 or so.  The seller then was
http://stores.ebay.com/nationwidesurplus in Phoenix.  I don?t see any
Edgeports in their eBay store now but there are a few 2-port models for
under $30.

My 4-port worked fine with my HB FSK/PTT interface (am now using a
microKEYER II), a Green Heron RT-21, my APC UPS (from
http://www.refurbups.com/ ), K3, and 87A.

As I remember, Windows 7 automatically installed the driver though the
manufacturer's website,
http://www.digi.com/products/usb/edgeport.jsp#overview, has them too.

Jim N7US



-----Original Message-----

Am I looking at the right product? The Digi Edgeport/2 is going for 
$100+, the /4 is $200+, and the /8 is listed $300+ on eBay. Looks like a 
nice solution if you need a multi-port solution.

But I was thinking along the lines of a single-port $20 device... like 
these on eBay: *http://tinyurl.com/4x6tfx8*

Or these on the open web... *http://tinyurl.com/3ujxn2h*

In either case, there are a variety of solutions that allow an RTTY 
operator to use century old technology on modern equipment!

73 de Bob - KØRC in MN

------------------------------------------------------------------------


On 6/13/2011 11:40 AM, Jim Rhodes wrote:
>
> The EdgePort multiport adapters that I use do a fine job on baudot.
> No EXTFSK needed. Check ebay for 4 and 8 port models.
> Jim K0XU
> Sent from my Droid X
>
> On Jun 13, 2011 11:29 AM, "Robert Chudek - K0RC" <k0rc@citlink.net 
> <mailto:k0rc@citlink.net>> wrote:
> > Hello Pete,
> >
> > The most effective solution is to use a software driver called EXTFSK.
> > This removes the need to find an "old" USB/Serial converter to run FSK
> > at 45 baud. Using this software driver with MMTTY allows just about any
> > modern USB/Serial device to work. There is an issue though, to ensure
> > the USB/Serial converter works it's best to find a device based upon 
> the
> > FTDI chip set (as opposed to the Prolific chip set).
> >
> > Here's a link to the FTDI site: http://www.ftdichip.com/FTProducts.htm
> >
> > Make certain the converter you purchase says it uses the FTDI chipset
> > and driver. The Prolific chipset "might" work, but it's a crap shoot,
> > depending upon its age and software driver.
> >
> > So there's two pieces to the puzzle... Using the EXTFSK software driver
> > with MMTTY and using an FTDI based converter for the hardware 
> connection.
> >
> > 73 de Bob - KØRC in MN
> >


_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>