If SolarEdge applies their fix and the noise is still too high, it is possible
they missed one panel. That happened with one of my neighbors about two years
ago. They finally got it right on the fourth service call. Now I don't have
any RFI from that house. So, get them to come back, pull off every panel and
check that every optimizer has added ferrites on both the inputs and outputs
and the wires are twisted.
Randy KQ6RS
-----Original Message-----
From: RFI <rfi-bounces+r55stan=gmail.com@contesting.com> On Behalf Of Tony
Sent: Wednesday, September 23, 2020 9:53 PM
To: Rfi List <rfi@contesting.com>
Subject: Re: [RFI] pleasant surprise today from Solar Edge
James:
Solar Edge used the same suppression techniques on my neighbors installation
and it only reduced the noise from S-9 +15 db to S-9 which is still very high.
I suspect that the suppression would be more effective on installations that
emit lower-levels of RFI so it would be interesting to know how strong the
noise was prior to the suppression being installed and what the results were
afterward.
The distance from your antenna to the solar panels is another factor so it
would be helpful to know that as well.
Congratulations.
Tony -K2MO
On 9/23/2020 9:29 PM, WW3S wrote:
> My neighbor across the street had a 21 panel Solar Edge array
> installed in May 2019, 6.5 kw I believe. I had the 18kc noise spikes,
> and the 200kc spaced optimizer noise. After working with Paul at the
> ARRL, who contacted the Solar Edge technical team on my behalf, Solar
> Edge committed to fixing the problem. They were supposed to come out
> in the spring, but of course current events prevented that. A visit
> was scheduled for early September, but the local crew needed to
> cancel. So I was suprised to see their van at the neighbors bright and
> early this morning. While the panels were disconnected, I took so more
> sdr sample screenshots, of course no noise. The engineer from Solar
> Edge appeared, and we had a brief chat about the course of action they
> were going to take. replace all 21 optimizers, twist all the DC
> wiring, and install ferrites on all the leads in to the optimizers. I
> had to leave for an appt this afternoon, and they were gone when I got
> back, but......it appears to be successful !!! The 200kc optimizer
> noise certainly is gone, no notice of it at all on the sdr, and the
> other noise seems gone as well. I only had a short time to check, but
> it certainly seems to have knocked most, if not all, of the noise
> down.....(insert emoji for jumping on soapbox) No matter how you feel
> about the ARRL, they are really the only game in town as far as
> supporting the amateur radio community with regards to RFI and
> spectrum defense. If you can spare a few bucks, send it to them. If
> you are not a member, think about joining.
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|