How do you tell what boot version your ap1000 is? None of mine have bnc
connectors on them.
John
----- Original Message -----
From: "Caleb Carroll" <karlnet@pathcom.ca>
To: <blair@wmwisp.net>; "Karlnet Mailing List" <karlnet@WISPNotes.com>;
<karlnet@WISPNotes.com>
Sent: Wednesday, December 08, 2004 7:36 PM
Subject: Re: [Karlnet] RE: 4.46 released
>
> Read the bloody e-mail from Reg. It says:
>
> ***
> Known Issue:
>
> 1) AP-1000 units with boot version 3.20 should not be upgraded to
versions
> higher than 4.44-02.
> ***
>
> AP-1000's with BNC connectors all have 3.20 boot prom.
>
> *********** REPLY SEPARATOR ***********
>
> On 2004-12-08 at 12:21 PM Blair Davis wrote:
>
> >I am using 4.46 on my AP-1000E / Wavepoint II-E units. No special
> >problems found so far.
> >
> >DON'T try to put 4.46 on an AP-1000 / Wavepoint II (units with the BNC
> >connector) unless you want to go replace / reload the unit. It WILL
> >cause the unit to lock up.
> >
> >Preparing to load 4.46 on my flashroms and on my OR-500 / OR-2 and
> >RG-1x00 units later today.
> >
> >Blair Davis
> >West Michigan Wireless ISP
> >269-686-8648
> >
> >A Division of :
> >Camp Communication Services, INC
> >
> >
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|