What Firmware did you upload to the AP-1000? I've only ever used SA-4400.
Was the EnGenius card in the AP-1000 when you uploaded the firmware to the
AP-1000? If so, upload the firmware without the EnGenius card in the AP-1000.
Does the AP-1000 boot and work in TC mode with a regular Orinoco card?
What firmware version do you have on the card? Anything better than 1.4.9 or
1.5.6 should be fine. Have you tried another EnGenius card?
*********** REPLY SEPARATOR ***********
On 2003-May-02 at 9:32 PM Bob Hrbek wrote:
>Well, I'm trying to use TC mode. The AP-1000 doesn't even boot up
>completely. I hangs with a red light on the PC led that the card is
>plugged
>in, regardless of slot A or B.
>
>It is an EnGenius 200mW card from Netgate.com
>
>Any thoughts?
>
>-bob
>----- Original Message -----
>From: "Leszek Olszewski" <leszek@oslink.pl>
>To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
>Sent: Friday, May 02, 2003 3:45 PM
>Subject: Re: [Karlnet] Prisim cards in AP-1000's
>
>
>> They don't work in 802.11b mode, they only work in Turbocell mode.
>>
>> One of the bugs that supposedly don't exist.
>>
>> Leszek
>>
>>
>> At 15:13 2003-05-02 -0500, you wrote:
>> >I just ordered a few of the 200mW cards from netgate.com
>> >
>> >I stuck one in a 4.31 Karlnet AP-1000 and it won't boot with the card
>> >inserted. Any ideas?
>> >
>> >I thought any Prisim 2 card worked.
>> >
>> >hmm
>> >
>> >_______________________________________________
>> >Karlnet mailing list
>> >Karlnet@WISPNotes.com
>> >http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>> _______________________________________________
>> Karlnet mailing list
>> Karlnet@WISPNotes.com
>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
|