We are using the Senao (EnGenius) 200mW cards in the new RG+ boards. You
have to load the bin file before you put the cards in or you will get the
red light.
Hope this helps.
Don
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Bob Hrbek
Sent: Friday, May 02, 2003 9:33 PM
To: Karlnet Mailing List
Subject: Re: [Karlnet] Prisim cards in AP-1000's
Well, I'm trying to use TC mode. The AP-1000 doesn't even boot up
completely. I hangs with a red light on the PC led that the card is plugged
in, regardless of slot A or B.
It is an EnGenius 200mW card from Netgate.com
Any thoughts?
-bob
----- Original Message -----
From: "Leszek Olszewski" <leszek@oslink.pl>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Friday, May 02, 2003 3:45 PM
Subject: Re: [Karlnet] Prisim cards in AP-1000's
> They don't work in 802.11b mode, they only work in Turbocell mode.
>
> One of the bugs that supposedly don't exist.
>
> Leszek
>
>
> At 15:13 2003-05-02 -0500, you wrote:
> >I just ordered a few of the 200mW cards from netgate.com
> >
> >I stuck one in a 4.31 Karlnet AP-1000 and it won't boot with the card
> >inserted. Any ideas?
> >
> >I thought any Prisim 2 card worked.
> >
> >hmm
> >
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|