It is funny you said that....
This is connected via a crossover cable...
And it was setup by default too 10 Mbit/sec Half Duplex (Auto Port Select)
and it didn't like giving me a network connection.
Access it via the wireless card and change the Ethernet Interface to Auto
Speed Auto Duplex and now it works.... grrrr
Maybe it is my laptop... I doubt it...
I have never setup a Flashrom or RG like this before... But this is my first
time to mess with these AP-1000s.
Problem Solved....
Nate
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of Terry Bomersbach
Sent: Tuesday, October 01, 2002 2:29 PM
To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] AP-1000 Goofyness
I experienced it when I set the ethernet to Auto Speed Auto Duplex on a
goofy switch. I went back to 10mbit half and it worked fine.
----- Original Message -----
From: "Nate McLain" <nate@ctrail.net>
To: <karlnet@WISPNotes.com>
Sent: Tuesday, October 01, 2002 1:34 PM
Subject: [Karlnet] AP-1000 Goofyness
> I have a AP-1000 that doesn't work right.
> I can see it via a scan of the configev program.
> Once I flashed the radio with the proper bin file and license the ethernet
> port NEVER comes back up... You never get a connect to it with a crossover
> cable.
> But I can access it via a wireless connection. The ethernet port is
enabled
> but still no go. I have verified that the crossover cable it good..
>
> Has anyone else seen this problem??
> I can't figure out why the ethernet port is just dead.
>
> Nate
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|