Yes, but is the default IP address of the KarlNet Bridge firmware the same as
the default IP address of the Orinoco AP1000 AP?
Assume NOTHING. If the default addresses are different before and after
firmware flash, then it would make sense that you would have to reconfigure
your configuration computer to the new address/subnet before you could
continue.
But then again, maybe not.....
At 01:34 PM 10/1/02 -0500, you wrote:
I have a AP-1000 that doesn't work right.
I can see it via a scan of the configev program.
Once I flashed the radio with the proper bin file and license the ethernet
port NEVER comes back up... You never get a connect to it with a crossover
cable.
But I can access it via a wireless connection. The ethernet port is enabled
but still no go. I have verified that the crossover cable it good..
Has anyone else seen this problem??
I can't figure out why the ethernet port is just dead.
Nate
Roger Boggs
|