I don't see any way to upload the .bin file to the AP. There is no option to
"Upload Software" until after you Open the Remote Config. Config ver:
3.86.10.
Jim
----- Original Message -----
From: "Support" <support@karlnet.com>
To: <karlnet@WISPNotes.com>
Sent: Tuesday, August 20, 2002 12:28 PM
Subject: RE: [Karlnet] Forced reload problem
> Jim,
>
> In forced reload you can only upload software. You can not do an Open
> Remote or access the unit. This is normal and cannot be changed. Load
the
> bin file in Forced reload and then reboot in normal operation mode and you
> can access the unit.
>
> Doug Harman
> KarlNet, Inc.
> 525 Metro Place North
> Suite 100
> Dublin, OH 43017
> 614 822-5275 x 123
> 614 822-0024 fax
>
> > -----Original Message-----
> > From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> > Behalf Of Jim
> > Sent: Tuesday, August 20, 2002 11:05 AM
> > To: karlnet@WISPNotes.com
> > Subject: [Karlnet] Forced reload problem
> >
> >
> > I have an AP-1000 in forced reload mode and I can use the configurator
to
> > scan it. I then change the IP address and try to connect to the
> > unit. I get
> > a message back which says "Signature of remote bridge is not
recognized.".
> > Is there anyway to access the unit?
> >
> > Jim
> >
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
|