CQ-Contest
[Top] [All Lists]

Re: [CQ-Contest] 40m "new" approach to staying in the band?

To: CQ Contest <cq-contest@contesting.com>
Subject: Re: [CQ-Contest] 40m "new" approach to staying in the band?
From: Zack Widup <w9sz.zack@gmail.com>
Date: Sat, 7 Nov 2009 11:09:42 -0600
List-post: <cq-contest@contesting.com">mailto:cq-contest@contesting.com>
I don't quite get the complaint about 14150.5. Is it that MOST of the RF is
in the band but the suppressed sideband may yet still be there? If you could
be guaranteed of only a USB signal being there, it would not be illegal to
use this frequency on USB. I listened to several SSB signals on 20m and
switched to the LSB position and couldn't hear a thing. So I assume they
were suppressed below the minimum requirements. That's easy to do with
today's rigs.

73, Zack W9SZ

On Fri, Nov 6, 2009 at 9:01 PM, DF3KV <df3kv@t-online.de> wrote:

> Hi Mark,
>
> That is exactly what I wanted to point out.
> Working LSB on 7125.5 or USB on 14.150.5 makes your transmission illegal.
> During the recent WWDX many stations were operating outside their frequency
> allocations, 14149kHz was busy all the time.
> I also heard many Europeans working US stations above 3.8MHz which is
> illegal either.
>
> 73
> Peter
>
> -----Original Message-----
> From: kd4d@comcast.net [mailto:kd4d@comcast.net]
>
> LSB on 7125.5 is DEFINITELY outside the US phone allocation.  This is the
> opposite
> of the situation of USB on 14.150.5.  USB means most of the RF is ABOVE the
> suppressed carrier frequency (the displayed frequency);  LSB means most of
> the RF is BELOW the suppressed carrier frequency.
>
> In the US, these aren't band plans as they are in many other countries
> but regulations.
>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest

<Prev in Thread] Current Thread [Next in Thread>