Reported by whom?
What did they use to measure it?
Did you get a second opinion?
Is it your exciter?
Are you over driving your radio from the computer?
Since you run 1KW on FT8, have you been put on the "BUD" list and banned
from FT8 for life?
Everyone knows that you can't run more than 1 microwatt on FT8....
Thanks
73
Jim W7RY
On 5/23/2021 11:35 AM, Conrad PA5Y wrote:
Hi all.
I have several tetrode amplifiers that run from a 3PH 50Hz supply. With the
advent of the FT8 I have become aware that I have 300Hz sidebands at only
-50dBc, this is obviously unacceptable. The supplies are from Rhode and
Schwartz and are very well made and use an 8uF oil filled capacitor for
smoothing. Some of the EU amateurs will know the supply, it is known as an IN
026 A1.
I suspect that this problem has always been there.
What is interesting is that Class AB1 or Class C, 100W out or 1kW out from the
PA the sidebands are -50dBc. I did consider the G1 and G2 supplies but 300Hz
suggests the 3PH supply and this happens with 3 different amplifiers, the only
common factor is the HT supply. If it was ripple, I would have expected this to
change depending on Anode current, but it doesn't. Unless of course the
capacitor is completely shot. I will check that next, it's a little difficult
to get to.
The PSU details can be found here:
https://www.dropbox.com/s/l71qj1g3qv7zh73/Servive%20Doc%20UHN284.pdf?dl=0
Any ideas?
Regards
Conrad
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|