You probably know this, but the clips get weak when they overheat. So
it's not enough to tighten it up, but you should replace it. You can
switch it with one of the clips on the grid pins.
On 5/13/2014 10:33 AM, Gary Smith wrote:
My dad's PT2500 has a problem where one of the 3-500 pins gets hot
enough it unsolders. I'm going to have a look at it & am thinking
maybe there's a poor connection on that pin/clip but maybe its
something relating to a defective component.
Before I open it up I'd appreciate suggestions on what to
specifically look for that might not be obvious to the eye, might
save me some time reinventing the wheel.
73,
Gary
KA1J
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|