My dad's PT2500 has a problem where one of the 3-500 pins gets hot
enough it unsolders. I'm going to have a look at it & am thinking
maybe there's a poor connection on that pin/clip but maybe its
something relating to a defective component.
Before I open it up I'd appreciate suggestions on what to
specifically look for that might not be obvious to the eye, might
save me some time reinventing the wheel.
73,
Gary
KA1J
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|