Re: [Amps] Question on soft start board location on a SB1000

[Bill Turner <dezrat1242@yahoo.com>]

ORIGINAL MESSAGE:          (may be snipped)

On Thu, 7 Nov 2013 10:43:51 -0800 (PST), Mike wrote:

>   I was wondering if anyone on the list has installed one of these on their 
>SB1000, how and where did you install yours?

REPLY:

I installed a homebrew step-start board on top of the power transformer as
you suggested. Its been about 20 years, but as best I recall I fabricated
some mounting brackets and used the transformer bolts.

73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps