I used stainless steel hose clamps for the cathode connection on my 160-meter
amplifier using a pair of GI-7bT Russian tubes. The heaters were the size of
the plate cap on a 6146 so I used a couple of them.
http://k9sth.com/uploads/160-meter_amplifier_article-1.pdf
For a pair of GS-31b tubes (160-meter through 10-meter amplifier) I made clamps
out of copper sheet. However, hose clamps would work well for the GS-31B,
GS-35b, etc.
Glen, K9STH
Website: http://k9sth.com
________________________________
From: "Bill, W6WRT" <dezrat1242@yahoo.com>
Too risky for my taste. Make a clamp. Even alligator clips. :-)
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|