That's how I recall doing it last time without any problems.
I'll go for that again. And if something pops, they don't dig deep holes in the
pocket :-)
Thanks!
73's
Ulf (SM0NOR)
ulf@sm0nor.com
On 16 maj 2012, at 00:04, Glen Zook wrote:
> I only ran my new GI-7bT tubes for a few hours on just the heater before
> applying high voltage. They are working fine in my home-brew 160-meter
> amplifier.
>
> Glen, K9STH
>
> Website: http://k9sth.com
> From: Ulf (SM0NOR) <ulf@sm0nor.com>
> To: Amps reflector <amps@contesting.com>
> Sent: Tuesday, May 15, 2012 2:31 PM
> Subject: [Amps] preparing unsed gi7b:s?
>
> Hi Forum,
>
> What are you guys doing to prepare GI7b:s for first time use? I recall
> playing with one some years ago and I don't remember doing anything special
> apart from running it on filament for a day before applying HV.
> What do you recommend?
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|