Amps
[Top] [All Lists]

Re: [Amps] soldering vs crimping

To: "Roy" <royanjoy@ncn.net>, <Amps@contesting.com>
Subject: Re: [Amps] soldering vs crimping
From: "Carl" <km1h@jeremy.mv.com>
Date: Fri, 4 May 2012 14:59:52 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Relays and PIN's regularly smoke.

The solder is there only to insure a continuing low resistance contact and 
not to increase power handling.

Carl
KM1H


----- Original Message ----- 
From: "Roy" <royanjoy@ncn.net>
To: <Amps@contesting.com>
Sent: Friday, May 04, 2012 11:04 AM
Subject: Re: [Amps] soldering vs crimping


> "Its always better to crimp AND solder the center conductor unless you 
> feel
> lucky but dont blame the connector if it blows in a contest or
> pileup......especially the QRO crowd."
>
>
>
> Gosh...and all that destructive power passed through the tiny contacts in 
> my
> QSK relay or my tiny PIN diode at 1500 watts? Six amps?
>
> 73,   Roy         K6XK         Iowa
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2411/4977 - Release Date: 05/04/12
> 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>